Tag: satellitedish.com

Do you really need DiSEqC dish positioners?

Our Positioners are DiSEqC Problem Free …

TECH TIP

What is DiSEqC?

Its short for Digital Satellite Equipment Control a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small ku dish antenna rotor (Stab). DiSEqC was developed by European satellite provider Eutelsat.

FACT Is it needed with a big C band Dish?

Not Really. Some offshore FTA receivers claim to interface properly with its commands to move the dish with one remote control. Many times this information is incorrectly received and causes a host of problems. DISEqC protocol is sent using your coax cable. This will cause attenuation to your signal and is not recommended by Rainier. You want maximum signal going to your receiver. The best way to move a big dish is to use a DISEqC mover in manual mode.

Our Positioner’s don’t have DiSEqC circuitry and operate independently from your receiver. This setup assures no DiSEqC related problems, plus allows maximum satellite signal to your receiver for a better digital lock.

Our Mighty Mini and Primesat EZ 2000 Plus are DisEqC Problem Free.
They utilize manual mode with a simple interface, and cost less.

WE HAVE BIG DISH POSITIONERS IN STOCK! NO WAITING!!!

SATELLITE DISH POSITIONERS ~ RARE! One of a Kind ~

Looking for Rare No longer made satellite dish positioners? Rainier to the Rescue. Were cleaning out our Warehouse and need to find these a good home. We have a few NOS models in stock were selling out. Usually only one is available of each so when its gone its gone. ORDER TODAY! Take a look below.

Titanium Satellite ASC1 Positioner/Polarization Controller

IN STOCK One Available. New Old Stock.

V-Box 7 DiSEqC Positioner/Controller

IN STOCK One Available. New Old Stock. Rainier Satellite Upgraded.

Need help selecting products? CALL 509-486-4137

 

NEW ITEM! EZ-2000 PLUS Satellite Dish Positioner

Rainier Satellite Does it again. We came up with a Low Cost Solution to move your satellite dish.  Rainier Welcomes the New Primesat EZ-2000 Plus to our webstore. This is a Rainier Satellite Exclusive.

At a time where the economy is rocky and no movers are available Rainier Satellite addresses both needs.

LOW COST AND AVAILABILITY!  

About the EZ-2000 Plus:

REPLACEMENT FOR JAEGER, SUPERJACK, MOTECK V-BOX I/II/III, V-BOX 7, PRIMESAT V-BOX PR1200.

Works with all C band FTA and Subscription receivers. Why settle for something used or 240 volts from offshore, no voltage converter needed. These units are brand new and work on 110 to 120 volts AC for North America. Standard US Plug. Compatible with all kinds of Actuators and H-H mounts. Drive dish size up to 3.6m. Fine-tune function for better reception. Anti-noise circuit to avoid miscounting. Full function IR remote control. Programmable 32 Satellites Direct Entry Remote. Short-circuit protection. Output Voltage 36 VDC. Output Current 3.5A Max. Main Supply Voltage AC120V / 60Hz. Power Consumption 80W. 2 digit LED display, 4 digit LED dish moving status bar..

Included:

1 x EZ-2000 PLUS Positioner

1 x Remote Control

1 x Owners Manual

In Stock

Order Yours Today.
Short on Cash? Pay in 4 and PayPal Credit Available.

Item ID PS2000

Dish Positioners In Stock ONLY at Rainier Satellite

All US sources of dish positioners has dried up except us. Only Rainier Satellite has units in stock at our Tonasket Washington headquarters. They’re ready to ship TODAY!

Can’t move your dish? Let Rainier come to your aid.

110 volt designed for the US market.
Works with our D9865 or FTA Receivers.
In Stock at our Tonasket Washington Headquarters.

Strong – Simple – Easy Setup Dish Positioner.

Works Great with the Rainier D9865 Satellite System.
Replaces the 4DTV as a dish mover in any system.
FTA Friendly Can be used independently to move your dish.
Accurate, Dependable, Bug Free Operation for Large Dishes.

SHOP WITH CONFIDENCE   Rainier Satellite is Open for Business During the COVID-19 Pandemic