Tag: tek2000

Do you really need DiSEqC dish positioners?

Our Positioners are DiSEqC Problem Free …

TECH TIP

What is DiSEqC?

Its short for Digital Satellite Equipment Control a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small ku dish antenna rotor (Stab). DiSEqC was developed by European satellite provider Eutelsat.

FACT Is it needed with a big C band Dish?

Not Really. Some offshore FTA receivers claim to interface properly with its commands to move the dish with one remote control. Many times this information is incorrectly received and causes a host of problems. DISEqC protocol is sent using your coax cable. This will cause attenuation to your signal and is not recommended by Rainier. You want maximum signal going to your receiver. The best way to move a big dish is to use a DISEqC mover in manual mode.

Our Positioner’s don’t have DiSEqC circuitry and operate independently from your receiver. This setup assures no DiSEqC related problems, plus allows maximum satellite signal to your receiver for a better digital lock.

Our Mighty Mini and Primesat EZ 2000 Plus are DisEqC Problem Free.
They utilize manual mode with a simple interface, and cost less.

WE HAVE BIG DISH POSITIONERS IN STOCK! NO WAITING!!!

SATELLITE DISH POSITIONERS ~ RARE! One of a Kind ~

Looking for Rare No longer made satellite dish positioners? Rainier to the Rescue. Were cleaning out our Warehouse and need to find these a good home. We have a few NOS models in stock were selling out. Usually only one is available of each so when its gone its gone. ORDER TODAY! Take a look below.

Titanium Satellite ASC1 Positioner/Polarization Controller

IN STOCK One Available. New Old Stock.

V-Box 7 DiSEqC Positioner/Controller

IN STOCK One Available. New Old Stock. Rainier Satellite Upgraded.

Need help selecting products? CALL 509-486-4137

 

NEW ITEM! EZ-2000 PLUS Satellite Dish Positioner

Rainier Satellite Does it again. We came up with a Low Cost Solution to move your satellite dish.  Rainier Welcomes the New Primesat EZ-2000 Plus to our webstore. This is a Rainier Satellite Exclusive.

At a time where the economy is rocky and no movers are available Rainier Satellite addresses both needs.

LOW COST AND AVAILABILITY!  

About the EZ-2000 Plus:

REPLACEMENT FOR JAEGER, SUPERJACK, MOTECK V-BOX I/II/III, V-BOX 7, PRIMESAT V-BOX PR1200.

Works with all C band FTA and Subscription receivers. Why settle for something used or 240 volts from offshore, no voltage converter needed. These units are brand new and work on 110 to 120 volts AC for North America. Standard US Plug. Compatible with all kinds of Actuators and H-H mounts. Drive dish size up to 3.6m. Fine-tune function for better reception. Anti-noise circuit to avoid miscounting. Full function IR remote control. Programmable 32 Satellites Direct Entry Remote. Short-circuit protection. Output Voltage 36 VDC. Output Current 3.5A Max. Main Supply Voltage AC120V / 60Hz. Power Consumption 80W. 2 digit LED display, 4 digit LED dish moving status bar..

Included:

1 x EZ-2000 PLUS Positioner

1 x Remote Control

1 x Owners Manual

In Stock

Order Yours Today.
Short on Cash? Pay in 4 and PayPal Credit Available.

Item ID PS2000

New Product! 4×8 Powered 18 volt Ortho Logic Switch

 

Using a Ortho feed? Insert the right voltage to power both LNB’s properly for maximum signal. No more starving your vertical polarity with 14 volts. The Rainier 4×8 switch provides the logic control needed for up to 8 receivers. It sends 18 volts to up to 4 LNB’s for c or C/ku operation. Logic control accepts 14 /18 switching input for 0k or 22k tone operation. Use our D9865 and Linkbox or other FTA receivers at the same time. Includes 4X8 multiswitch, AC /DC linear power supply module, and F to F adapter. Order today.

Did You Know? If you’re using a FTA receiver it only sends 14 volts to the vertical LNB. This low voltage will not allow your LNB to operate well and receive signals properly. Fix it with Rainier’s 4X8 multiswitch solution.

Did You Know? That LNBF’s dont give the same performance as dedicated LNB’s with an ortho feedhorn. Dump the lossy LNBF today and see the difference.

See our Ortho Feeds and LNB’s Here

-Necessary Add On For All FTA Receivers Using Ortho Feed.

-Can be used with the Rainier Cisco D9865 receiver for improved performance.

-Use with our Linkbox 500i FTA/IP receiver.

-Increase performance of your receiver.

-Lock unlockable signals.

-Provides proper 18 volts to each LNB connected.

-Receive weak signals.

-Connect up to 8 receivers using the same dish.

-Powers up to 4 LNB’s, C & Ku.

-Covers 950-2150 MHz.

 

NEW PRODUCT RELEASE!

Rainier Satellite is pleased to announce a new product in our lineup for 2022. The Mighty Mini ED. This replaces all legacy SD and HD units. Whats special about our new model. It packs more power (amperage) in its mini design to move up to 12 foot mesh dishes effortlessly. Its the highest amperage consumer dish positioner on the market today.  Forget those weak V boxes. Our Mighty Mini runs rings around them.

Check out it’s Features:

  • New Powerful 3.6 Amp Maximum Current moves up to 12 foot mesh dishes.
  • New Extra Duty Model (MMBDT-EX)
  • Power Punch for fast startup.
  • Powerful 36 Volts DC delivered to M1 & M2 terminals.
  • 10 Amp 110 VDC rated dual motor relays.
  • Compact Design. (sits next to our D9865 receivers)
  • Super Simple Installation Setup.
  • One Button Direct Satellite Tuning.
  • 32 Direct Entry Satellite positions.
  • Non-volatile memory.
  • Compatible with any Actuator including H to H using a reed, hall, or optical sensor.
  • 5 volt rear terminal for optical sensor.
  • Electronic Overload Protection.
  • Anti-miscounting design.
  • Large “easy to read” Green LED Display.
  • LED bars show dish movement direction.
  • Full Size Remote and buttons, 37 Keys. Easy to use.
  • Countdown memory clear reset function.
  • Full Function IR remote control.
  • Dimensions 3.75″ L, 11.0″ D, 3.75″ H.
  • AC Voltage in, 115v 60 Hz.

Works Flawlessly with Rainier and FTA systems.

Order Today!

LAST DAYS TO GET THE MIGHTY MINI FOR NEXT TO NOTHING!

This SALE ENDS February 8th, 2022. Hurry only a few left at this unheard of LOW LOW price of $95.99 with Free Fed Ex Shipping!

Works flawlessly with Rainier Subscription or FTA Systems!

TOMORROW MAY BE TOO LATE!

Mighty Mini Big Dish Positioner After Christmas Super Sale!

SALE ENDS FEBRUARY 8, 2022
OR UNTIL LIMITED QUANTITY RUNS OUT.

Get the worlds best big dish positioner at the lowest price ever. Includes FREE FED-EX Shipping. Only for a limited time. Grab one up before the limited quantity at this special price is gone.

Works flawlessly with FTA Systems!

Read the Mighty Mini’s Review from a Satisfied Customer Here

Satellite Dishes UP TO 16.4 feet Available! IN STOCK!

Be is small or large Rainier’s got you covered. C band satellite dishes are hard to come by these days for some. Those who sourced cheap low cost dishes from China are no more. Where does that leave those who need a big dish such as TV, Radio Stations, backyard dish subscribers, and hobbyists. Well stop looking, Rainier has sizes between 9 and 16.4 feet available made right here in the USA.

Stop looking endlessly, no supply chain issues with Rainier. Come to the leader in Satellite communication products and services, Rainier Satellite LLC. founded in 2013.

Cord Cutter Low Cost TV Solution

NEW RECEIVER FROM RAINIER!

Cord Cutters, Looking for a low cost TV solution for your big dish? Look no further than Rainier. We now offer a FTA / IPTV receive at a low cost just for you, Receive channels for free, no subscription required with our new Linkbox 500i receiver. Pansat / Linkbox has been around a long time and is a name you can trust.

Receives HVEC, H265 up to 32PSK, and has a built in USB PVR. Grab one today.

Note: Does not receive Rainier Satellite Subscription TV. Use our D9865 here for our pay programming. Availability of FTA channels may vary.

 

50% off on our Mighty Mini Dish Positioner Ends Soon!

HURRY SALE ENDS AUGUST 31st. Don’t Miss out!!

Get the best Dish Positioner out there Period!

Only $74.99, Limited Quantity left at this low price